LIGHT UP YOUR BUILD
The Liquid Freezer II A-RGB combines the efficient, award-winning PWM pump of the Liquid Freezer II with new A-RGB fans optimized for static pressure. This gives you a whole new aesthetic with extremely low noise and equally low temperatures.
EFFICIENT, IN-HOUSE DEVELOPED PUMP
Unlike many of our competitors, we went to great lengths to develop the water pump. The result is greatly reduced humming and higher efficiency. Like the other components, the pump is also PWM controlled. This leads to a significantly lower noise level at low and typical loads, but also to much lower power consumption, with a maximum of of 0.8 W at no load, 2.5 W under normal load and a maximum of 5.3 W under full load for the entire AiO.
PREMIUM CLASS RADIATOR
Unlike most other all-in-one liquid cooling manufacturers, we rely on 38 mm thick radiators with a high fin density. This means that a larger amount of water can be used in the circuit, and the cooling surface can be significantly increased.
Water has a much higher heat capacity than aluminum or copper. This leads to a slower and up to 5° C lower temperature increase in the temporary turbo mode of modern CPUs.
SMOOTH VRM FAN
Small fans have a reputation for being particularly loud and not very durable. However, we have developed a quiet and durable diagonal fan especially for the Liquid Freezer II and are 100% convinced that this 40 mm fan is just as durable as our other case fans. In the unlikely event that it should fail, our customer service team will send you a replacement free of charge and easily, without a need to replace the entire unit.
The fan is PWM-controlled and can cool your voltage transformers and the base area almost inaudibly by up to 15° C. This is especially effective in overclocking scenarios, inadequate VRM cooling or in housings with poor airflow, thus permitting continuously high loads. If sufficient VRM cooling is available, it can be switched off at will.
TECHNICAL SPECIFICATIONS & MANUAL
Intel Socket:1200, 115X, 2011-3, 2066 Square ILM
Ram Clearance: unlimited
Operating Ambient Temperature:0 - 40 °C
Connector: Cooler: 4 pin PWM Connector
LEDs: 3 pin 5 V-DI-GND Connector
VRM Fan:40 mm, 1000, 3000 RPM (PWM controlled)
Pump:800, 2000 RPM (PWM controlled)
Power Consumption:0,5 W, 2,7 W (Pump + VRM Fan)
Cold Plate: Copper, Micro-Skived-Fins
Thermal Paste:MX-5 (0,8 g)
Fan:3x ARCTIC P12 PWM A-RGB 120mm Fan
Fan Speed:200, 1 800 RPM
Fan Bearing: Fluid Dynamic Bearing
Noise Level:0.3 Sone
Voltage / Current:0.08 A / 12 V DC
Static Pressure:1.85 mm H2O
Connector:4 pin Connector
LEDs:12 A-RGB LEDs per Fan
Connector:3 pin 5 V-DI-GND
Current/Voltage:0.4 A/ 5 V
Size & Weight
Radiator:398 x 38 x 120 mm
Pump (w/o tubes)98 mm x 78 mm x 53 mm
Tube Diameter: Outer: 12,4 mm // Inner: 6,0 mm
Tube Length:450 mm
Weight:1729 g (Fan, Radiator, Pump, Tubes)
Width: 142 mm
Height: 167 mm
Length: 414 mm
Weight: 2.25 kg